Description
G1/2 DC12V Pressure-Free(Direct acting) Normal Closed Plastic Solenoid Valve requires no minimum operating pressure or pressure difference, so they can be used from 0 bar up to the maximum allowable pressure. It is typically used for relatively small flow rates. This is a G1/2 DC12V Pressure-Free Normal Closed Plastic Solenoid Valve that you can use to control the flow of a liquid using your computer or microcontroller.
The 12V-DC solenoid valve is compatible with 1/2-inch (4-inch) threaded coupling, suitable for use with water and low viscosity fluids, normally closed, power supply and valve open. Therefore, if the water is released Water (or liquid) enters the solenoid when the solenoid is not being supplied, the water will be blocked, but if the power is supplied (Providing the magnetic mechanism inside the solenoid ), just the right amount will cause the valve to open and the water will flow through it.
Description
Name:1/2” DC 12V Solenoid Valve
Material: PP plastic
Voltage: DC 12V
Current: 1A
Operation model: Direct acting normally closed (N/C)
Pressure: about 0 – 0.01Mpa
Port size: about G1/2”
Fluid temperature: about 0-90℃
Size: Total length: 72mm
Total width: 36mm
Total height: 57mm
Thread: G1/2 “male thread
Thread length: 17mm
Fixed pitch: 25 * 25mm
